You found the refill tube pushed down inside the overflow pipe.
What’s actually happening
The refill tube and overflow pipe โ highlighted below โ is where a misplaced tube can siphon water.
Ads
The thin refill tube sends a little water down the overflow pipe after each flush, to refill the bowl. Its end is meant to sit above the pipe, clipped to the rim.
When the end is pushed down inside the pipe, below the water level in the tank, it can act like a siphon. Fluidmaster, which makes toilet parts, explains that water then drains from the tank into the bowl, the tank level drops, and the fill valve turns on again: the refilling you hear.
Putting it right costs nothing and takes about a minute.
Ads
Put the tube back where it belongs
- Pull the end of the tube out of the overflow pipe.
- Clip it to the rim of the pipe so the end stays above the water line. If the clip is missing, the tube can rest on the rim as long as its end stays above the water.
- If the tube is so long that it keeps curling down into the pipe, trim it so it just reaches the rim.
- Flush once, then listen over the next half hour.
If it still refills by itself
Then the tube wasn’t the only cause, and the next thing to check is whether water is getting past the seal at the bottom of the tank. See what to check when water leaves through the bottom of the tank.
Written by the Fix Editorial Team ยท Based on toilet-part manufacturer guidance (Fluidmaster) and established home-maintenance and plumbing cost sources (Angi, Modernize) ยท Last updated September 27, 2026.
This content provides general household information and does not replace an in-person assessment when one is needed.
