Open the hood with the engine cool and use a flashlight. Coolant leaks leave wet streaks, drips or a dried crust in the color of your coolant. Follow the trail upward: coolant runs down and back as you drive, so the wet spot on the ground is usually behind and below the real source.
The location narrows the cause fast. At the very front, behind the grille, sit the radiator and its two big hoses. Under the engine, toward the middle, are the water pump and thermostat housing. The reservoir is the translucent plastic tank with a cap, usually off to one side.
Most of these are parts a mechanic replaces in under an hour, and several are hose-and-clamp jobs a careful owner can do at home. The next page for your answer shows what a healthy part looks like, how to confirm the leak, the part to look up for your vehicle, and when a radiator or water pump repair is better left to a shop.
How to read a coolant stain
- Wet and shiny: the leak is active. Wipe it dry, run the engine to temperature with the cap on, and watch where the first new drop forms.
- Dry white or colored crust: a slow seep that evaporates as it leaks. Common at hose clamps, the water pump weep hole and the seams of a plastic radiator tank.
- Puddle only after a drive: the system is under pressure when hot, so hairline cracks in the reservoir, radiator or thermostat housing open up only then.
- Never open a hot cap: the system is pressurized above boiling point. Wait until the engine is cool to the touch before removing the radiator or reservoir cap.
What each location usually means
- Front of the car: radiator core or end tanks, upper or lower radiator hose, hose clamps, radiator drain plug. Radiator hose replacement and radiator leak repair are the common outcomes.
- Under the engine: water pump seal (look for the weep hole), thermostat housing gasket, heater hoses, freeze plugs. Water pump replacement is the most frequent repair here.
- Around the reservoir: a cracked tank, a worn cap seal, the overflow hose, or the small hose to the radiator. Cheapest fixes of the group.
- Can’t tell: a cooling system pressure test or UV dye finds a leak in minutes. The next page shows both, and when to hand it to a mechanic.
