Think back to the last few times it went off balance. If it only happens with a comforter, a bath mat, a very small load or a very full one, choose “Only certain loads.” If it happens with ordinary, everyday loads too, choose “Almost every load.”
An off-balance spin leaves clothes wetter, stretches cycle times, and repeated hard banging puts extra stress on the parts that hold the drum steady. Most of the time the cause is simple: how the washer is loaded, or how it sits on the floor.
Once you know the pattern, the next page walks through the exact check for it and what it usually points to. Three steps: identify the pattern, find the cause, fix it.
Questions people ask
Why does my washer keep going off balance?
The two broad causes are the load (too small, too full, one heavy item, or items that tangle) and the washer itself (not level, not sitting firmly on the floor, or worn parts that hold the drum steady). Whether it happens with every load or only some is the quickest way to tell them apart.
What does UE mean on an LG washer?
It means an unbalanced load. A lowercase uE means the washer is still trying to fix it on its own; LG says that after three unsuccessful attempts it switches to an uppercase UE, which means it needs you to redistribute the load. Some LG models show Ub instead.
What does Ur mean on a Samsung washer?
Samsung describes Ur as an unbalanced-load retry: the washer adds water, rebalances and tries to spin again. It makes the cycle longer, but on its own it doesn’t mean anything is wrong with the machine. Codes like Ub or UE, depending on the model, mean it couldn’t finish balancing.
Is some shaking normal?
Yes. Samsung notes that a little vibration at the start of a cycle is expected while the washer senses the weight of the load. Repeated hard banging, a machine that shifts across the floor, or a spin that keeps restarting is not.
Should I stop the washer if it’s banging hard?
If it’s banging hard or starting to move, pause the cycle, wait for the door or lid to unlock, and spread the laundry evenly before restarting. Letting it hammer through a full spin over and over isn’t good for the machine.
