Toilet Running Non-Stop? Check This First

One look inside the tank tells you the repair you need.
Ads

Lift the lid, then watch the overflow tube (the open pipe in the tank’s middle) for 30 seconds while it fills — then answer below.

Is water spilling over the top of the pipe and down into it?
1 · Identify the pattern → 2 · Find the cause → 3 · Fix it

Why this check comes next

When a toilet runs without stopping, water is either coming into the tank and never shutting off, or leaving the tank and never stopping. The overflow tube shows which one: it only carries water when the tank fills above its normal level.

Toilet-part manufacturers and plumbing guides start with this same look, because it takes seconds and needs no tools. The next page explains exactly what your answer means.

Ads

What each answer usually means

If you picked water spilling into the pipe, the tank is filling past where it should — almost always because the fill valve or the float that tells it when to stop isn’t shutting off in time. This is what people usually mean by a toilet that won’t stop filling, or a tank that keeps running even though nothing looks obviously broken. In many cases, simply adjusting the water level (lowering the float, or turning the adjustment screw on newer fill valves) is enough to stop it before any part needs replacing, and the next page walks through exactly how.

If you picked the top of the pipe staying dry, the tank itself is filling normally, so the water loss is happening after the flush — usually because the flapper isn’t sealing all the way and lets water leak into the bowl. That’s a different, and often simpler, repair: a flapper swap rather than a fill valve adjustment. The next page covers how to confirm it and fix it.

Find the right next step

Match what you saw inside the tank to the right check.

Water spills into the overflow pipeThe tank fills past a safe level, whether or not anyone has flushed. See the fill valve check →
The top of the pipe stays dryThe tank fills normally, but water keeps leaving after a flush. See the flapper check →

Questions people ask

Why won’t my toilet stop filling?

Almost always because the fill valve or float isn’t telling the tank to shut off at the right level. Water keeps rising until it spills into the overflow tube, which is what sends it down the drain continuously.

Can I just adjust the water level myself?

On most fill valves, yes. Lowering the float, or turning the adjustment screw on newer valves, tells the tank to shut off sooner. If that stops the water from spilling into the overflow tube, the fill valve itself may be fine and just needed adjusting.

Is it expensive to leave a toilet running non-stop?

It can waste a meaningful amount of water over a day, since clean water goes straight down the overflow tube the whole time it runs. It’s not usually an emergency unless water reaches the floor, but it’s worth checking soon.

If there’s water on the floor

Water running inside the tank stays inside the toilet. If you see water on the floor around the toilet, or the bowl rising toward the rim, turn the knob on the wall behind the toilet clockwise until it stops, and call a plumber before doing anything else.

Written by the Fix Editorial Team · Based on toilet-part manufacturer guidance and established home-maintenance sources · Last updated September 27, 2026.
This content provides general household information and does not replace an in-person assessment when one is needed.